Brightwell Xport-BIO Media
Today's savings: 51%
Brightwell Xport-BIO Media
An ideal choice for heavily stocked aquatics, the Brightwell Xport-BIO Media is effective in rapidly decreasing nitrate and ammonia concentrations. It has a higher efficiency in relative to conventional media results in small spaces needs for achieving equal nitrification. In synthetics biological filtration, this media has the highest colonizable surface area-to-volume ratio. This media can also help in creating enhanced material that has a vast surface area by beneficial nitrifying of bacteria for colonization. It results in efficient and rapid conversion of ammonia into nitrate.
- Effective in rapidly decreasing nitrate and ammonia concentrations
- Highest colonizable surface area to volume ratio
- Creates enhanced material that has a vast surface area
- Results in efficient and rapid conversion of ammonia into nitrate
- Higher efficiency in relative to conventional media results
Read all instructions before use. The use of a mechanical pre-filter to remove particulate organic material from water prior to its interaction with this media will improve efficiency. Rinse Xport-BIO in purified water or low-TDS fresh water, then place media into a clean pail and fill with water from the aquarium into which the media is to be placed. Seed each 150 g of Xport-BIO used with 20-ml of MicroBacter7 (poured into the pail and dispersed by hand), then allow media to remain in this "bath" for 24-hours at room temperature. Remove Xport-BIO from pail and pour water into the aquarium system, then place Xport-BIO into canister filter, media reactor, or 800µm mesh filter bag; a flow-through rate of 1 - 3x the total aquarium volume per hour is recommended. Do not fluidize. Remove and rinse ~33% of the total Xport-BIO employed in a pail of discarded aquarium water (when performing a water change) once or twice each month, and place media back into use. Apply 1-ml of MicroBacter7 per 20 US-gallons (~76 L) in system to aquarium in an area of high water flow to fortify media after rinsing.
Xport-BIO is not a chemical filtration media; it must be seeded with appropriate bacteria to begin nitrification. Simply placing Xport-BIO into an established aquarium will slowly seed the media, however seeding with MicroBacter7 as directed above will significantly decrease cycling time and therefore results in faster results. In all systems, begin with a ratio of 150 g Xport-BIO per 300 US-gallons (1,136 L) in system. Nitrification will typically begin within one day; rate of nitrification increases with time (generally mature within 2 weeks) and increasing nitrogen content in system. If plants and/or zooxanthellate invertebrates (e.g. corals, clams, etc.) appear to react negatively to the use of Xport-BIO, it may be an indication that nitrogen is being removed too aggressively; NeoNitro or FlorinGro may be employed to provide nitrogen as nitrate, and feeding with the appropriate foods is necessary for all zooxanthellate invertebrates. Note that the required amount of Xport-BIO may change as the system matures, and as biomass and/or stocking density changes; high-nutrient systems may require a greater ratio of Xport-BIO to water volume, evident as a persistent ammonia presence regardless of how much MicroBacter7 is employed.